C200H-HI / C200H x4 / C250H-HI
C250HI LE / C250H x4 / C250H x4 LE
85
Coolant circuit: Draining
The coolant should be changed according to
“Table of fluids and lubricants“
(references and capacities), or when the circuit is drained for repair purposes. To do so,
proceed as follows:
- Place a container below the radiator.
- Disconnect the lower radiator hose in order to drain the radiator here.
Coolant circuit: Filling and bleeding
- Before filling the circuit, re-connect the lower radiator hose.
- The circuit is filled through the coolant reservoir (Isuzu 4LE1 Engine) and through
the filling cap
(fig. 1)
(Kubota V2403-M).
Proportions of coolant and distilled water:
Temperatures from -17 ºC to 127 ºC: 40 % glycol and 60 % distilled water.
Temperatures from -35 ºC to 145 ºC: 50 % glycol and 50 % distilled water.
-
Start the engine until the thermostat opens.
-
Then, when the engine is cold, check the level of coolant in the coolant
reservoir.
NOTE
Although the cooling system is equipped with a self-bleeding system, refer to
an authorized AUSA dealer for the replenishment of the coolant after draining
it.
Dispose of used coolant in authorized centres.
Air
filter
Replacing
The air intake in the engine is through a dry filter
(fig. 2, 3)
with double element. The
life of the engine and its performance largely depend on the correct maintenance of this
filter.
The filters should be changed and cleaned as shown in the
MAINTENANCE CHART
.
If the forklift is working in a dusty atmosphere the filter element should be replaced more
often than that specified.
NOTE
The intake filter includes a filter blocked clogged indicator. If the warning light
on the control panel lights up and the acoustic warning is heard, the filter
element should be cleaned or replaced as soon as possible.
CAUTION
Do not start the engine when there is water inside the air filter casing. When
there are fluids or dirt inside the casing, the filter cartridges should be inspected,
drained or replaced.
(fig. 3)
(fig. 2)
(fig. 1 – K
U
B
O
TA
V2403-M)
(fig. 3 - ISUZU 4LE2)
Periodic
Maintenance
Operations