When the forklift overturns or is knocked onto one side, restore it to normal operating
position (on all four wheels).
WARNING
DO NOT TRY TO START THE FORKLIFT without first checking with an
authorized AUSA dealer.
- Remove the four glow plugs.
- Turn the key in the ignition to position
(c)
. Hold the key in position until the oil has
come out of the combustion chamber.
WARNING
The oil will come out of the combustion chambers at high pressure and may
cause injury.
- Re-assemble the four glow plugs.
- Check the engine oil level and refill if necessary.
- If the engine oil pressure warning light remains lit after starting the engine, stop
immediately to prevent internal damages and refer contact to an authorized
AUSA dealer as soon as possible.
Immersion of the forklift
If the forklift becomes submerged under water, it will be necessary to take it to an
authorized AUSA dealer as soon as possible.
WARNING
DO NOT START THE ENGINE. Immersion of the forklift may cause serious
damage to the engine if the start-up procedures are not followed correctly.
- Arrange for an authorized AUSA dealer to carefully inspect the supply system as
shown in the
MAINTENANCE CHART
.
Storage and pre-parking preparation.
When the forklift is not to be used for more than a month it should be stored correctly.
When the forklift is brought out for use again after a period of storage, special preparation
is required. Ask an authorized AUSA dealer about the appropriate procedures.
Special procedures
C 400 H / C 400 HI / C 400 H x4 / C 400 HI x4
C 500 H / C 500 HI / C 500 H x4 / C 500 HI x4
72
