Engine
oil
Use 4-stroke engine oil in accordance with MIL-L-2104C / API CD or superior.
Verify always the quality in the attached etiquette in the container of the oil to make sure
that the quality is the required.
Your machine leaves the factory with SAE 15W40 viscosity. However, depending on
the environment temperatures, refer to the following chart
(fig. 1)
to select the proper
viscosity.
If you use oils of different brands, drain completely the oil pan before adding the new oil.
AUSA recommends oil REPSOL AUSA EFFICIENT for Diesel engines p/n 461.00099.01
Hydraulic
Oil
- VG 32 for environment temperatures usually below 50ºF (10ºC)
- VG 46 for environment temperatures between 50F to 120ºF (10ºC to 40ºC)
- VG 68 for environment temperatures above 120ºF (40ºC)
Front axle and FullGrip
®
System
Use oil for COMPEN AUSA which meets with the following characteristics:
- Friction coefficient modifying additives
- “Extreme Pressure” and anti-wear capacity
- Good antirust and anticorrosion characteristics
- Excelent thermal stability
- Avoids vibrations and noise
Brake and inching fluid
Only use SAE 10W Hydraulic Oil or ATF Fluid
Caution:
To avoid serious damage to the brake system or inching system do not use fluids other
than the recommended one, or mix different fluids for topping up.
Battery
electrolyte
This dumper is equipped with a type battery that requires maintenance. Add distilled
water for missing electrolyte.
C 400 H / C 400 HI / C 400 H x4 / C 400 HI x4
C 500 H / C 500 HI / C 500 H x4 / C 500 HI x4
74
Recommended
fluids and
lubricants
(fig. 1)
