Section 03
ENGINE
Subsection 11
(GEARBOX)
03-11-8
VMR2004_134_03_11A.FM
To remove bevel gear needle bearing
no. 36
and
main shaft needle bearing
no. 37
, use a punch.
1. Bevel gear needle bearing
2. Punch
1. Main shaft needle bearing location
2. Punch
Remove plain bearings
no. 39
and
no. 40
with the
proper plain bearing remover (refer to CRANKSHAFT/
BALANCER SHAFT).
To remove ball bearings
no. 42
and
no. 43
, use a
blind hole bearing puller.
Ball bearings
no. 38
and
no. 45
can be easily re-
moved with a suitable pusher from outside in.
The oil seals
no. 46
,
no. 49
,
no. 60
and
no. 61
are
removed easily with a flat screwdriver.
NOTE:
To remove oil seals
no. 34
,
no. 49
,
no. 60
and
no. 61,
the engine removal/disassembly is NOT
necessary (see OIL SEAL PROCEDURE above).
For ball bearing
no. 47
, remove screw
no. 43
then
push bearing from outside in with a punch.
1. Screw M6
2. Main ball bearing PTO side
Use needle bearing remover (P/N 529 035 756) to
remove needle bearing
no. 48
.
1
R400trans12A
2
tra
2
R400trans13A
tra
1
R610outi03A
1
R400trans14a
2
R400motr201a
