Section 03
ENGINE
Subsection 12
(CVT)
03-12-12
VMR2004_135_03_12A.FM
Fixed Half
Check ball bearing for free play and smooth oper-
ation. Replace if necessary.
Check shaft for heavy wear or visible damage. Re-
place if necessary.
If the shaft is removed, measure bushing diameter
with a dial bore gauge. Measuring point must be
at least 5 mm (1/4 in) from bushing edge.
This bushing is not replaceable. Replace fixed half
if bushing
no. 28
is out of specification. Visually
inspect coatings.
Check torque gear
no. 24
for visible damage and
wear limit with a caliper.
A. Measurement inside
B. Measurement outside
Cam
Check cam
no. 29
for visible damage and wear limit
with a caliper.
1. Contact surfaces for power train
2. Caliper
A. Width to be measured due to wear on contact surface
1. Caliper
2. Sliding half
3. Contact surface
A. Wear to be measured
BUSHING BORE DIAMETER
MAXIMUM (new)
30.000 mm (1.181 in)
MAXIMUM (new)
30.020 mm (1.182 in)
SERVICE LIMIT
30.200 mm (1.189 in)
BUSHING BORE DIAMETER
MAXIMUM (new)
30.000 mm (1.181 in)
MAXIMUM (new)
30.020 mm (1.182 in)
SERVICE LIMIT
30.200 mm (1.189 in)
WEAR ON TEETH BOTH SIDES
SERVICE LIMIT
7.500 mm (.295 in)
A
R400motr184A
B
WIDTH ON TOP SURFACE
SERVICE LIMIT
6.000 mm (.236 in)
WEAR ON CONTACT SURFACE
SERVICE LIMIT
2.000 mm (.079 in)
1
2
R400motr185A
A
1
R400motr186A
3
2
A
