7
OPERATING INSTRUCTIONS
Please use both hands to
carefully empty the water tank.
●
Start Operation
1) Place the product in an upright position on a flat, steady,
stable, heat-resistant surface. Make sure there is nothing
flammable or heat sensitive within 100 cm (39 inches).
Operating the product in any other position could cause a
hazard.
2) Insert the plug into a suitable wall socket. The dehumidifier
is suitable for operation on an electricity supply having the
same voltage as that shown on its rating label.
3) Make sure the water tank is correctly located. (After
switching on the machine for the first time, if the "Bucket
Full" lamp illuminates, just pull out the water tank, check
the "float" lever is able to move freely, then return the water
tank to the correct position.)
●
When Bucket Full Light Is On
When the water tank is full the machine will stop and the "Bucket Full" light
will illuminate. The water tank should be carefully removed from the
machine by sliding it outwards from the front of the machine and it should be
emptied. When the empty tank is replaced properly into the machine, the
machine will start up and run normally.
When operating in low temperatures the surface of the dehumidifier's coil may
accumulate ice and effect the efficiency of the dehumidifier. When this happens
the machine will go into periodic defrost mode automatically. This is quite normal.
Defrost icon will come on, the compressor will cease operating and the fan will
continue to operate until the ice has thawed. As soon as the ice has melted, the
compressor will restart and continue the dehumidifying process. Defrost time may
vary depending on room temperature and humidity.
DEFROST
