1) Place the product dehumidifier in an upright position on a flat,
stable, heat resistant surface. Make sure there is nothing
flammable or heat sensitive within 100 cm.
Start Operation
2) Insert the dehumidifier’s power plug into a suitable wall socket
with electricity supply the same voltage depicted on the unit’s
rear rating label.
3) Ensure the water tank is inserted correctly into the body of the dehumidifier.
Note: if the “Bucket Full” light illuminates when turning it on for the first time,
just pull out the water tank, check that the “Float” lever moves freely, then return
the water tank into the correct inserted position.
When “Bucket Full” Lamp Is On
When the water tank is full the machine will stop and the “Bucket Full” light
will illuminate. The water tank should be carefully removed from the
machine by sliding it outwards from the front of the machine and it should be
emptied. When the empty tank is replaced properly into the machine, the
machine will start up and run normally.
Please use both hands to
carefully empty the water tank.
DEFROST
When operating in low temperatures the surface of the dehumidifier’s coil/evaporator
may accumulate frost/ice and affect the efficiency of the dehumidifier. When this happens
the machine will go into periodic defrost mode automatically. This is quite normal.
The “Defrost” lamp will come on, the compressor will cease operating and the fan will
continue to operate until the frost/ice has thawed. As soon as the frost/ice has melted, the
compressor will restart and continue the dehumidifying process. Defrost time will vary
depending on room temperature and humidity.
The dehumidifier should not be used below 5°C. If the dehumidifier freezes up, turn the
machine off for a few hours before restarting.
Castor wheel installation is recommended to avoid damage to floors.
1. Remove the castor wheels from the water tank/bucket of the dehumidifier.
2. Position the dehumidifier on its side.
3. Locate the arrow on the bottom of the dehumidifier and insert a castor wheel
according to the arrow direction.
4. Slide the castor wheel in as far as it will go. It will click into place.
5. Repeat steps 3-4 for the other castor wheels.
7
OPERATING INSTRUCTIONS
CASTOR INSTALLATION
