AUSPURE KITCHEN AusFroth-06, User Manual

Cold Milk Foam  

For making Cold Milk Foam, follow the steps below:

1.

   Make sure the frothing whisk “        ” is properly attached to whisk holder inside

         the milk jug before operation.

2.

   Fill the jug with fresh milk up to Max level indicated for frothing (300 ml). 

3.

   Connect the plug of milk frother to the power source according to its required 

         tandard rating power supply.

4.

   Turn the knob to “        ” Cold Milk Foam mode.

5. 

  Press the START/STOP button, the buzzer beeps once with the blue indicator

         light, the motor will start to rotate. 

6.

   The machine will end up its operation after 2 minutes and the LED light will turn

         into white from blue. It beeps once and the blue indicator light turns to white
         (STAND BY MODE).

7.

   After 30-sec of not using the machine, the indicator light keeps flashing for 3

         seconds with beeping 3 times and then stops and light turns OFF.

NOTE-1:

   The only stirring option will be functioning during this operation mode to

                 produce proper Cold Milk Foam. The built-in heater will not be active for this mode.

NOTE-2:

   The preparation time of Cold Milk Foam is 2 minutes. Once the preset build-in

                 timer reads 2 minutes of operation, the frothing will end.
 

2 min

10

Add the milk

and select the
desired option

Press the

start button

and wait

Finish &

ready to use

Attach the 

disk