1)
Cause: Dry Skin/Air-conditioned environment.
Solution: Apply conductive gel or saliva thoroughly to finger (Finger-Touch measurement).
Even water will help if conductive gel is not available.
2)
Cause: Not firmly against skin.
Solution: Make sure the Watch is placed securely on wrist.
3)
Cause: Muscle tremors caused by holding too hard.
Solution: Do not press hard - sufficient pressure to cause flashing only.
4)
Cause: Dead skin on wrist or finger.
Solution: Usually rubbing your skin with a towel will help.
5)
Cause: A thin layer of body oil can insulate the ECG signal from the watch back sensor.
Solution: Wrist the watch with a tissue or soft towel.
6)
Cause: Hairy skin.
Solution: Apply conductive gel to wrist.
7)
Cause: Irregular heartbeats.
Solution: N/A It is difficult to consistently pick up a reading for those with irregular heart beats.
Inconsistent response times are expected for those with arrhythmia.
8)
Cause: Battery Low.
Solution: It might be due to the battery level of the watch is low. Have the battery replaced by a
certified watch maker or send to Aussie Fit Sport Science as per Warranty.
Summary of Contents for Pulse QT
