7
6.Seat Post and Seat Post Cover Installation
Slide the Seat Post Cover(29) onto the Seat post(4).
Insert the Seat Post (4) into the Seat Post Bushing (75) on the tube of the Main Frame (1)
and then attach the Locking Knob (27) onto the tube of the Main
Frame (1) by turning it in a clockwise direction , lock the Seat
Post (4) in the suitable position.
Adjusting the seat post:
Turn the Locking Knob(27) in a counterclockwise direction until it
can be pulled out.Pull out the Locing Knob(27)and then slide the
Seat Post(4) up or down directin to the suitable position.Lock the
Seat Post(4) in place by releaseing the Locking Knob(27)and
sliding the Seat Post(4) up or dowm slightly until the Locking
Knob(27)
”POPS”down into the locked position.For added
safety,tighten the Locking Knob(27)in a clockwise direction.
Note:When adjusting the height of seat post,the maximum
insert depth mark line cannot highter than the edge of the
seat post cover.
7. Seat Cushion and Seat Sliding Tube Installation
Remove three M8 Nylon Nuts (33) and three Ø16xØ8x1.5Washers (10) from underside of
the Seat Cushion (34).
Then attach the Seat Cushion(34) onto the triangle plate of
Seat Sliding Tube(5) with three M8 Nylon Nuts (33) and three
Ø16xØ8x1.5Washers (10) that were removed.
Remove one Ø10 Washer (31) and one Sleeve Ø10(32) and
Seat Adjustment Knob M10(30) from underneath of the Seat
Sliding Tube(5) and then attach the Seat Slidiing Tube(5)
onto the Seat Post(4) with one Ø10 Washer (31) and one
Sleeve Ø10(32) and Seat Adjustment Knob M10(30) that
were removed.
