4
Preparation for Assembly
Remove grill and all packaging materials from the carton and place on a clean level surface. Some parts are packed
inside the grill body. Remove, unpack and inspect these parts as well.
NOTE: Before using your grill, read the instructions and your manual.
For easier set-up and assembly, follow instructions of each step in the order they are written as you look at the dia-
grams. If accessories mentioned in certain assembly steps do not come with your model, skip that step and proceed to
the next step that applies to your model.
If you have any questions or need help, go to
www.aussiegrills.com
or contact
Customer Service at 1-800-251-
7558
. Be sure to have the grill model number and serial number printed on the label located on the inside surface of the
rear leg. If you need replacement parts, look in the Parts List Section to find the exact parts you need.
If you need a
replacement part under warranty, a proof of purchase will be necessary
. You will be asked to forward your
proof of purchase via e-mail to csr@aussiegrills.com or to fax your proof of purchase to 423-639-1055 and reference
your model and serial number.
It is important to register your grill and retain your receipt.
Grill Assembly Instructions
Regulator-Valve Housing Assembly
Insert the end of the regulator valve nozzle into the open end of the burner tube (venturi). Align the holes in Regulator
Housing with the threaded holes in the grill firebowl and insert two 5/32 x .31” Bolts through the holes in the housing
into the threaded holes in the firebox. Tighten the bolts securely.
Burner Venturi Hole fits
centrally around Regulator
Valve nozzle.
View shown without
Housing for clarity
