6
Step 3
Igniter Housing Assembly
A.
Thread the Electrode Wire through the hole in the Igniter Housing and attach the end onto the pin at the bottom
end of the Piezo Igniter.
B.
Align the holes in the Igniter Housing with the threaded holes in the firebowl end. Insert three 5/32 x .31” Bolts
through the housing into the threaded holes. When installing the fourth bolt, first insert it through the ring at the end of
the Match Holder chain and then through the Housing and into the firebowl end. Tighten the bolts securely.
A
Igniter Housing
Electrode Wire
B
Match Holder
Step 4
Install Flavor Activator
A.
For Model 6TV1S, hang the Flavor Activator on the brackets at each end of the firebowl. The vertical tabs extend up
through slots in the Flavor Activator to hold it in position.
B.
For Model 6TV1U, place the Flavor Activator into the firebowl locating the legs of the Flavor Activator around the
brackets welded to the bottom of the firebowl.
A
B
5/32 x .31” Bolt
4 pcs
Piezo
Igniter
Piezo
Igniter
6TV1S
Flavor Activator
6TV1U
