Aussie Bonza 3 Elite, Assembly And Use Manual

18

Lift up and slide

Burner back.

FIG. 15D

9) Lift Burner up from the back and pull it towards the rear. In 

order to clear the warming rack, lean the burner to one side
and gently pull the burner mouth away from the  valve 
nozzle.  

(FIG. 15D)

FIG. 15E

10) Slide the Electrode through the keyhole slot. 

(FIG. 15E)

11) Use a pipe cleaner to clear insect nests from the inlet hole 

of main burner. 

(FIG. 15F

)  Open up the main burner holes 

with a small nail or wire. Use a brass wire brush to remove 
food particles and corrosion from the burner surfaces. 
Note: It is normal for surface rust to be present on the
burners. It can be wire brushed and coated with cooking 
oil periodically. Verify that there are no insects or insect 
nests blocking the inlet hole. 

Note: Before 

Re-assembly of the Burners 

you may wish 

to clean the rest of the Grill. 

(See Grill Body and Cart.)

Open up main burner 

holes with a small 

nail or wire.

Wire Brush

FIG. 15F

Pipe Cleaner

Re-assembly of the Burners:

1) After cleaning, refit the Burners. Slide Electrode into

keyhole slot and lay aside. 

(FIG. 15E)

2) Lift Manifold Shield up so you may see to slide Burner 

Venturi over valve nozzle. 

(FIG.15G)

Be sure the burner is 

positioned correctly over the nozzle. (

FIG. 15H

) Lower 

Manifold shield and make sure the Electrode wires are not 
tight or pinched.  

Manifold Shield

Valve nozzle.

Burner venturi hole must

fit centrally around the

injector nozzle.

FIG. 15H

FIG. 15G

FIG. 15

I

3/16” Gap

Electrode
Bolts

If no spark, Loosen bolts
and nuts;  adjust 3/16”
gap between electrode
tip and burner; then
retighten bolts and nuts.

3) Secure the Burner to the firewall with the two bolts and

nuts. Align the two holes in the electrode with the holes in
the burner, and replace the two bolts and nuts. 
Note: Burner may need to be twisted when aligning 
electrode. Adjust the Electrode as shown in FIG. 15

I

. 

4) Reinstall Rear Panel, Control Panel, and Control Knobs.
5) If grill is to be stored, coat Burners lightly with cooking oil 

and wrap in a protective cover to keep insects out.

6) Check burner operation after re-assembly.
7) Replace Flame Diffusers and Cooking Grids.