8
Raptor Electric Operator’s Manual
July 2012
Australian Pump Industries
STANDARD EQUIPMENT
Before proceeding with assembly of your new Aussie Eco Clean blaster, check that all parts listed below
are included.
1 Gun handle assembly and high pressure hose
1 Lance and nozzle assembly
1 Inlet hose connector assembly
HIGH PRESSURE SETTING
The high pressure pump is factory set to operate at its rated pressure. DO NOT ADJUST.
Tampering with the pressure regulator will void warranty and can be dangerous.
WARNING:
If pressure drops off, check nozzle for wear. Nozzles should be replaced on a regular basis (every month
for machines in regular use, every 3 months for machines used intermittently. Using the machine with the
incorrect nozzle size or worn nozzle will void warranty and can be dangerous to the operator.
ASSEMBLY AND PREPARATION FOR USE
Check the oil in the (A) pump
With the machine on a level surface the oil level should be level
with middle of side oil plug or sight glass. Do not overfill. If
necessary top up with SAE30W pump oil.
Do not mix different grades of oil as this may affect the
machine's performance.
If alternative oil is used first empty out existing oil by unscrewing
drain plug in bottom of machine.
NOTE
: Read this handbook thoroughly and follow all directions carefully before you begin using the
machine
Power lance
To assemble the lance, insert section 'B'
into section 'A' and screw together.
High pressure hose
Connect the high pressure hose to the threaded water outlet on the side of the
machine.
Water supply hose
Use a good quality hose (not supplied) of 13mm diameter and secure one end to the inlet hose connector
securely using worm drive clip. This connection must be tight to avoid leaks.
Water supply is by means of mains supply. Secure the free end of the hose to your tap using a suitable
tap adaptor (not supplied, available through all good hardware and garden supplies stores).
NOTE: A pump filter has been fitted to prevent the ingress of grit to the pump, ensure filter is clean before
using machine. This hydro-blaster can be used with cold or hot water up to 60ºC
A
A
B
