July 2012
Raptor Electric Operator’s Manual
9
Australian Pump Industries
OPERATING INSTRUCTIONS
The power washer is supplied with an amperage cut-out switch. Do not adjust. Adjusting amperage cut-out
switch voids warranty.
SWITCHING ON MACHINE
1.
Plug power cable into suitable power supply.
2.
Turn on water supply. NOTE: Tap should be fully open.
2.
Pull the trigger to expel air from the system. Water will trickle from the end of the lance when air is
expelled.
3.
Start motor at amperage protection switch.
4.
Check that there are no leaks in the line connections, pistol or power lance. Pressure begins when
the pistol trigger is squeezed.
SWITCHING OFF MACHINE
1.
Turn switch to OFF position.
2.
Turn off water.
3.
Release pressure in spray gun by pressing trigger until water only drips from the spray head.
4.
Release trigger on gun.
5.
Press safety latch on gun. This locks gun trigger and prevents accidental triggering.
6.
Unplug machine from power point.
7.
Disconnect water supply hose from machine.
CARE AND MAINTENANCE
AFTER EACH USE
If there is a danger of freezing anti-freeze should be mixed with the flush water or the machine must be
completely drained. After the final flush stop the machine. DO NOT allow the machine to idle for more than
15 seconds. This is particularly important when there is a danger of freezing. Do not run for longer without
water supply.
STORAGE
Store the washer in an upright position, preferably drained of water if there is a danger of freezing (or fill
with anti-freeze).
SAFETY … IMPORTANT
EXCESS ATOMISED MOISTURE CAN ENTER SWITCHES & MOTOR CONNECTIONS AND OVER
TIME MAY CAUSE FAILURE
KEEP THE MACHINE OUT OF MOISTURE LADEN ATMOSPHERES
WARNING .... DO NOT RUN EXCESSIVE BY-PASS
SWITCH MACHINE OFF WITHIN TWO MINUTES OF CEASING OPERATION AS EXCESSIVE BY-
PASS CAN CAUSE HEAT BUILD UP IN PUMP & SUBSEQUENT DAMAGE. EXCESSIVE BY PASS
RUNNING VOIDS WARRANTY!!
