8
TOASTING
WORKSATION LAYOUT
These units are likely to be installed next to
similar sized machines (e.g. Fryers) that will
perform complimentary roles. In most cases,
operators will be using this machine in
conjunction with a bench or suitable surface on
which burgers and other food products can be
assembled or prepared.
For this reason, we recommend that areas
between this unit and other machines and work-
surfaces be kept clear of any potential obstacle
or trip hazard. Work areas should also be
cleaned and floors should be oil-free to reduce
the likelihood of slipping.
It is anticipated that these machines will be
operating beneath a suitable exhaust/extraction
unit to reduce the ambient temperatures around
the operator.
SAFETY
GENERAL SAFETY
This machine contains no user-serviceable parts.
Austheat
®
Australia, one of our agents, or a
similarly qualified person(s) should carry out all
repairs. Any repair person(s) should be
instructed to read the safety warnings within this
manual before commencing work on these
units.
Steel cutting processes such as those
used in the construction of this machine
result in sharp edges. Whilst any such edges are
removed to the best of our ability it is always
wise to take care when contacting any edge.
Do not remove any cover panels that may
be on the machine (with the exception of
the circuit breaker cover.
This unit can get very hot, ensure everyone is
aware that the machine is operating and take
care to avoid contact with hot surfaces. (Refer to
installation for guide to ventilation)
Always ensure the power cable is not in contact
with hot parts of the machine when in use, and
ensure that if the cable is damaged in any way
that it is replaced immediately
Always use original spare parts. Genuine
Austheat
®
parts have been checked for
compliance and reliability and the use of non-
original spare parts may compromise the
function or safety of these units.
As part of the normal operation of this unit, hot
air is expelled out the front of the unit. Never
block or interfere with this air flow as the internal
temperatures may rise and component damage
can occur.
GENERAL FIRE SAFETY
Before using any hotplate adequate safety
measures should be in place. Such measures
should include, but not be limited to, having an
appropriate fire extinguisher or fire blanket
located nearby in case cooking oils on the plate
ignite. Refer to the appropriate regulations
pertaining to your operating environment for
details of the correct fire prevention measures
required.
SAFETY OF SERVICEPERSONS
Before servicing this machine it is necessary to
disconnect all power. These units are NOT
fitted with a mains isolating switch – as detailed
in the installation section of this manual, an all-
pole disconnection isolating switch should be
mounted and wired
external
to this machine. A
cooling circuit will remain “live” within these
units even when turned “off” at the control
panel. Please consider this before allowing
qualified servicepersons to gain access to the
machine.
