Austin Hughes Electronics Cyberview S217, User Manual

P.2

1.2   Regulatory Notice

Chapter 1

Legal Information

First English printing, October 2002
Information in this document has been carefully checked for accuracy; however, no guarantee is given to the 
correctness of the contents. The information in this document is subject to change without notice. We are not 
liable for any injury or loss that results from the use of this equipment.

Safety Instructions 

■

   Unplug equipment before cleaning. Don’t use liquid or spray detergent; use a moist cloth.

■

   Keep equipment away from excessive humidity and heat. Preferably, keep it in an air-conditioned enviro-

      nment with temperatures not exceeding 40º Celsius (104º Fahrenheit).

■

   When installing, place the equipment on a sturdy, level surface to prevent it from accidentally falling and 

      causing damage to other equipment or injury to persons nearby. 

■

   When the drawer is in an open position, do not cover, block or in any way obstruct the gap between it and

      the power supply. Proper air convection is necessary to keep it from overheating.

■

   Arrange the equipment’s power cord in such a way that others won’t trip or fall over it. 

■

   If you are using a power cord that didn’t ship with the equipment, ensure that it is rated for the voltage

      and current labeled on the equipment’s electrical ratings label. The voltage rating on the cord should be
      higher than the one listed on the equipment’s ratings label.

■

   Observe all precautions and warnings attached to the equipment.

■

   If you don’t intend on using the equipment for a long time, disconnect it from the power outlet to prevent

      being damaged by transient over-voltage.

■

   Keep all liquids away from the equipment to minimize the risk of accidental spillage. Liquid spilled on to

      the power supply or on other hardware may cause damage, 

fi

 re or electrical shock.

■

   Only quali

fi

 ed service personnel should open the chassis. Opening it yourself could damage the equip-

      ment and invalidate its warranty.

■

   If any part of the equipment becomes damaged or stops functioning, have it checked by quali

fi

  ed  service   

      personnel.

Regulatory Notices Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. 
Any changes or modi

fi

 cations made to this equipment may void the user’s authority to operate this equip-

ment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used 
in accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 
measures:

■

   Re-position or relocate the receiving antenna.

■

   Increase the separation between the equipment and receiver.

■

   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.