MOUNTING SURFACE (REF)
3.50" (REF)
**NOTE**
IF INSTALLING ADAPTER PRIOR TO INSTALLING VENT:
4.25" CUTOUT RECOMMENDED.
•
IT IS
CRITICAL
THAT YOU CENTER THE VENT BEFORE
•
MOUNTING TO ENSURE ALL FASTENERS ENGAGE MOUNTING SURFACE.
VENT HOSE TUBE
ASSEMBLY & INSTALLATION
STEP #3:
ATTACH VENT COVER BY SLIDING IT
•
BACKWARDS INTO THE VENT BASE.
MAKE SURE TO ALIGN THE MOUNTING
•
TABS TO THE MOUNTING SLOTS.
STEP #1:
PREPARE MOUNTING AREA BY CREATING A CUTOUT
•
FOR THE VENT BASE TUBE TO PASS THROUGH.
(RECOMMENDED DIAMETER IS 3.50")
BASE WILL CONFORM TO NON-FLAT MOUNTING
•
SURFACE
ATTACH VENT BASE TO VEHICLE MOUNTING SURFACE
•
BY USING (CUSTOMER PROVIDED) #8 FASTENERS
THROUGH THE PROVIDED WASHERS.
STEP #2:
ATTACH VENTILATION HOSE TO THE 3" OR 4" SECTION
•
OF THE VENT HOSE ADAPTER.
THEN ATTACH VENT HOSE ADAPTER TO VENT BASE BY
•
USING TAPE AND/OR FASTENERS. (SEE ILLUSTRATION
TO RIGHT)
STEP #4:
LASTLY, SECURE VENT COVER BY INSERTING
•
(CUSTOMER PROVIDED) #8 / #10 FASTENER IN THE
REAR HOLE OF THE VENT.
NOW THE ENTIRE VENT ASSEMBLY IS SECURELY
•
CONNECTED THE VEHICLE.
REV
K
VENT ASSEMBLY
DESCRIPTION:
PART NUMBER:
THIRD ANGLE
PROJECTION
12-15-2014
CREATION DATE:
FILE NAME:
CREATED BY:
dlay
TEMPLATE REV 4/7/2011
www
.
austinhardware
.
com
DIMENSIONS MAY CHANGE WITHOUT NOTICE
INFORMATION ON THIS DRAWING BELONGS TO AUSTIN HARDWARE AND MAY NOT BE REPRODUCED OR DISTRIBUTED WITHOUT PERMISSION.
Sheet3 of 3
Y_VT-2758-A03
VT-2758-A03
