ALC UIM PC2027XX_0521
Pull the chain all the way out from
the binder and to connect the
bottom hook to your binding chain
at the furthest point.
Pull the control plate again and
move handle back to the middle
section, release the control plate
then start tensioning by moving the
handle up and down. The bottom
hook will begin to tension.
You only need 50kg on handle to achieve approximately 750kg force between
the hooks. This is higher than Australian Standard requirement which has
been requested by BlueScope and other Australian Companies.
NOTE:
For your safety, you must stand on firm, flat, non-slip ground
when using the Maxibinder.
STEP 5
STEP 6
STEP 7
Bottom
Hook
MAXIBINDER USER MANUAL
5
MAXIBINDER USER MANUAL
