ZONEMIX
INSTALLATION AND OPERATION MANUAL
17
CONNECTING ZMPS PAGING STATIONS CONT.
ZMPS CONFIGURATION
The ZMPS allows each button to be configured as either
• Zone Select (Single or Group)
• Pre-recorded Announcement
• Disabled
Select a button to show the drop down of assignable actions
ZONE SELECT
Select the “Zone Select” option from the dropdown list and then select which zone/s it should control using the zone buttons controls.
You can select a single zone or multiple zones if you wish to create a paging group.
Example: First two buttons are set as single zone selection, buttons three and four are set as zone group buttons
PRE-RECORDED ANNOUNCEMENTS
A button can also be set to play a pre-recorded announcement
1. Select the “Paging Message” option from the button dropdown list
2. Select the message to be played from the file explorer window
Note: You must have an SD card installed with WAV audio files available
3. To playback the pre-recorded message select the zone/s and then press the assigned message button
PRE-RECORDED MESSAGE PLAYBACK
To playback a pre-recorded message, select the zone/s that the message should be sent to and press the assigned message button.
Note: You must also assign other buttons to be “Zone Select” buttons to allow the user to select the appropriate zone/s
before the announcement is played.
IDENTIFY MODE
If you need to identify which ZMPS is being controlled by the Zonemix software,
• Press the “Identify” button on the paging station tab in the “Pager Configuration” window
This activates the ZMPS LEDs (Flashes every 500ms)
Press any button on the paging station to cancel the identify state
• Alternatively, read the serial number on the rear of a ZMPS and match it to the paging station info shown in the paging station tabs.
