1
230 to 240V or 115V to 120V
The power input is NOT auto-switching. Australian Monitor should be contacted
if the voltage needs to be changed from its shipped configuration. The power
input also features a power switch, this is a hard power off and will shut down
the unit completely.
2
Amp Outputs:
The output for each channel can be either 100V Line, 70V Line or 4 Ohm low
impedence. Only one output type should be used at once.
3
Inputs
Balanced line-level inputs on 3-pin XLR. Pin 1 Ground, Pin 2 Hot, Pin 3 Cold.
Input level trim for attenuating input signals.
4
USB Input
The USB input is for future use.
5
Logic Controls
VCA:
When a RC1 or 500K pot is connected between a VCA pin and the GND,
connected audio can be remotely controlled.
Low Power Mode:
When the low power mode pin is connected to the GND pin
the unit will enter low power mode.
RS232:
The AMD Power P series can be controlled via RS232.
See page page 7 for more information.
1
2
3
4
5
PIN 1
GND
PIN 2
HOT
(+)
PIN 3
COLD
(–)
Female XLR
PAGE 5
AMD4200P INSTALLATION AND OPERATION MANUAL
REAR PANEL
POWER
