EXTENDING CAT5 CABLE RUN DISTANCES & ADDING MORE PAGING STATIONS
The maximum distances quoted in the Table #1 are due to DC current limitations, not data
transmission limitions. If distances greater than these are required, the paging stations can
be locally powered. This will extend the maximum distances to 1000m per CAT5 RUN.
Alternatively, if more than 4 paging stations are required on a single run, local powering can
be used. This will increase the maximum number of paging stations on a single CAT5 RUN.
Use a regulated 12VDC supply connected as
pin1 (white/green in CAT5)- GROUND
pin2 (green in CAT5) - +12V
Disconnect inV, but not ground. The 12V supply should be rated at 150mA per
microphone being powered. For further information email help@audiotelex.com.au.
TONE GENERATOR INPUTS
Tones may be triggered by closing a switch or relay contact between the selected tone
trigger input and common. These trigger inputs are 5V TTL and may alternatively be triggered
by pulling the desired input low referenced to the COMMON.
PRE-ANNOUNCE CHIME
The only internal setup that is available in the DigiPageJr is for the configuration of the chime
tone that sounds in each zone. The unit comes shipped with the chime enabled in all zones.
A link can be found on the main board just behind the zone control boards (see diagram).
To disable the chime to a particular zone, remove the link. To re-enable the chime, replace
the link.
NOTE: The maximum voltage on these inputs must not exceed 5.5V
INSTALLATION SERIES
Australian Monitor
Zone
1
Zone
2
Zone
3
Zone
4
Zone
5
Zone
6
Zone
7
Zone
8
13
NOTE: Remember to wait for the chime to finish before speaking. Note that when
the chime is disable it will still activate but will not be heard so you must still
wait approximately 1 sec before speaking after press the page button.
