6
LIRLBE00-03
Operation
AUTEC - Air series
6 Operation
6.1
electronic module
The electronic module contains the address key, where the radio remote control configuration
data are also stored. The receiving unit cannot work without this address key.
6.2
DiP switches
DIP switch 1 is used to set the frequency band.
DIP switch 2 shall always be set in the OFF position: do not modify it.
6.3
internal light signals
The activation of each relay on the mother board is signalled by an LED near the relay.
6.4
Command outputs
The data sheet contains information regarding the correspondence between the commands
sent by the transmitting unit and the related output enabled in the receiving unit.
Summary of Contents for Air ACRS13-L
Page 8: ......
