en/TA-11-ALM-6040/10040FL
pag.: 13
USER /
INSTALATION
MANUAL
4-POST HD
ISSUED 26-05-04
A L M - 6 0 4 0 F L
A L M - 1 0 0 4 0 F L
AUTEC Hefbruggen bv
Industrieterrein IJsselveld, Vlasakker 11, 3417 XT MONTFOORT, The Netherlands
Tel: +31 348 477000 Fax: +31 348 475104 Internet: www.autec.nl - E-mail: info@autec.nl
3.5.4
Risk for sliding out.
This risk can be overcome by
avoiding the spillage of oil or
grease in the area surroun-
ding the lift
(fig. 8)
.
Apart from that, any oil
spillage which may occur
should be thoroughly removed
from the spot immediately.
Fig. 8
3.5.5
Risk for electrocution.
Never spray water steam, sol-
vents or paint in the area imme-
diately surrounding the platform
and the control cabinet
(fig.9)
fig.9
3.5.6
Risk due to insufficient lighting
The area surrounding the lift must be properly lighted according to the legal requirements applicable in the place
of installation.
3.5.7
Risk of use/maintenance
Autec uses material of the highest quality in its lift. These must be used according to the standard specified, and
maintenance must be carried out regularly.
3 . 6
S u i t a b i l i t y f o r u s e .
This product has been manufactured in compliance with the European Directive 89/392. On the
basis of article 4.1.2.3 of this Directive, the coefficients used tor the tests are as follows:
1.10 for the dynamic test.
1.25 for the statie test.
These tests must be performed by specialist staff.
Any unauthorized modifications or tampering with the equipment release the manufac-
turer
of responsibility for the damages caused by or related to the above men-
tioned acts.
The removal of or tempering with safety devices constitutes an infringement of
European Safety Regulations.