en/TA-11-ALM-6040/10040FL
pag.: 25
USER /
INSTALATION
MANUAL
4-POST HD
ISSUED 26-05-04
A L M - 6 0 4 0 F L
A L M - 1 0 0 4 0 F L
AUTEC Hefbruggen bv
Industrieterrein IJsselveld, Vlasakker 11, 3417 XT MONTFOORT, The Netherlands
Tel: +31 348 477000 Fax: +31 348 475104 Internet: www.autec.nl - E-mail: info@autec.nl
Check that the oil pump works properly by pressing the descent button
(23)
to lower the lift as far as the lower
stop; press the rise button
(22)
and raise the lift 10 cm. Then lower it once again and repeat the operation 3 or
4 times, checking that during the rise movement each pump pumps oil into the containers
(19)
. Re-fit the flaps
(18)
by using the screws
(17)
in all four posts.
Check that the obstacle safety switches work properly. Check that the microswitches work by activating them
manually. The descent movement should halt. Then operate the rise movement to raise the lift about 10 cm.,
place a wooden wedge under cross piece
(1)
at a distance of 15 cm from the post
(30)
and lower it in short
bursts until the cross piece
(1)
rests on the wooden wedge. Carefully watch cross piece
(2)
which is opposite
the rest point. It should come to a stop automatically when the descent switch is pressed a few more times.
Repeat the test placing the wooden wedge under cross piece
(2)
.
fig. 18