AUTEC Modular series, User Manual

 4 

Operating mode 

of “Master/Slave”

- 17 -

LIMM&SA0-00.fm

 4

OPERATING MODE OF “MASTER/SLAVE”

 4.1

Command “Take/Release 2” or “Release 2”

POWER ON AND 

START UP

1

2

COMMAND 

“TAKE/RELEASE 2” OR 

“RELEASE 2”

1

2

POWER ON AND 

START UP

COMMAND 

“TAKE/RELEASE 2” 

OR “RELEASE 2”

Transmitting 

unit UTX-M

The transmitting unit UTX-M has a “Take/Release 2” command that engages and releases the 
receiving unit URX-2.
In order for the transmitting unit UTX-M to take control of the receiving unit URX-2 during start 
up or working:
- press the START pushbutton and do not release it until the lamp (or horn) ENA-M of the re-

ceiving unit URX-2 switches on with 

ON blinking fast

- activate the “Take/Release 2” command within 3 seconds
A 

steady ON

 signal of the lamp (or horn) ENA-M indicates that the connection has succeeded.

From now on, the transmitting unit UTX-M completely controls the receiving unit URX-2, which 
cannot be used by the transmitting unit UTX-S.
In order to release the receiving unit URX-2, activate the command “Take/Release 2” again. An 

OFF

 status of the lamp (or horn) ENA-M confirms that the unit has been released. When the 

transmitting unit UTX-M is switched off but has not released the receiving unit URX-2, the lamp 
(or horn) ENA-M stays 

ON blinking slowly

.

Transmitting 

unit UTX-S

The transmitting unit UTX-S has a “Release 2” command to release the receiving unit URX-2.
During start up the transmitting unit UTX-S engages automatically the receiving unit URX-2, if 
it is free: press the START pushbutton and do not release it until the lamp (or horn) ENA-S 
switches on with 

steady ON

.

From now on, the transmitting unit UTX-S completely controls the receiving unit URX-2, which 
cannot be used by the transmitting unit UTX-M.
In order to release the receiving unit URX-2, activate the command “Release 2”. An 

OFF

 status 

of the lamp (or horn) ENA-S confirms that the unit has been released. When the transmitting 
unit UTX-S is switched off but has not released the receiving unit URX-2, the lamp (or horn) 
ENA-S stays 

ON blinking slowly

.