8
Programming
- 26 -
LIMM&SA0-00.fm
8.2
Programming the receiving module
To change the programming set in the radio module, it is necessary to open the receiving unit.
The group of eight dip switches located on the radio modules is used to program some functions
and set the working frequency. The programming set in the other group of four dip switches
must never be modified.
For the correct functioning (see paragraph 1.7), the group of 8 dip switches (ex-
cluding DIP 1) for the radio modules E16STXEU_ and E16SRXEU_ must be set in
the same way.
Set the group of 8 dip switches as described below:
Group of
8 dip switches
Pay particular attention when closing the unit at the end of the operation.
Receiving unit URX-1 in the “Master/Slave” system
Receiving unit URX-2 in the “Master/Slave” system
Receiving units URX-1 and URX-2 in the “Master/Master” system
Radio module corresponding to the
transmitting unit UTX-M
Radio module corresponding to the
transmitting unit UTX-S
Radio module corresponding
to the transmitting unit UTX-M
DIP MODULE STATE
FUNCTION
1
E16SRXEU_
ON
Stop after 0.35 sec with invalid radio signal
OFF
Stop after 1 sec with invalid radio signal
2
a
a. With MK12 transmitting units this dip switch must be at ON.
E16SRXEU_
ON
Deactivation of low battery warning from horn on machine
OFF
Activation of low battery warning from horn on machine
3-7 E16SRXEU_ ON/OFF
See paragraph 1.7 and paragraph 8.5
8
E16SRXEU_
ON
Manual selection mode of the frequencies using DIP 3 - DIP 7 (see
paragraph 8.5)
OFF
DO NOT USE
