45
Chapter 4
Flight Operation
4.1 Check list before flight
Perform comprehensive check before flight by the following steps:
Fully charge the aircraft battery, remote controller and your mobile device.
Take down the gimbal protective cover.
Confirm that the propeller is intact and correctly installed.
Set the position of the remote controller antenna as per 2.2.2.
Pair the aircraft battery and the remote controller.
Check that the firmware has been upgraded to the latest version indeed.
Ensure that you are familiar with flight control operation.
Check whether the flight area is open without obstacle.
Check the weather, including the window and the air speed.
Check whether the camera lens and sensor of the aircraft is clean.
4.2 Flight operation
This aircraft includes three rocker modes: American manipulator, Chinese manipulator and
Japanese manipulator. Each mode has different control on the aircraft. The default mode is the
American manipulator. The user can switch in Autel Explorer App according to operation habits,
and the American manipulator is recommended for the beginner.
Basic flight
1. Place the aircraft at an open area. Stand at least 5 m (15 ft) from the tail of the aircraft.
2. Turn on the remote controller.
3. Turn on the aircraft, and wait the LED indicator at the tail to turn green and flash slowly.
4. Start the motor with the remote controller to take off.
5. Carefully navigate and manipulate the aircraft.
6. Land down the aircraft, and turn off the motor.
4.2.1 Motor start and aircraft takeoff (American manipulator)
As shown in figure, press the left and right
rockers
for 2s to start motor:
or
Summary of Contents for EVO II Pro Enterprise
Page 1: ...1 EVO II Enterprise User Manual ...
Page 26: ...26 ...
