27
Figure 5.24
You can save the code results for later review by selecting the
Save
option on the bottom. When you finish viewing the DTCs, press the
ESC
button to return to the previous screen.
5.3.2 Erase Codes
After reading/reviewing the diagnostic trouble codes, take the
following steps to erase codes from the vehicle. If
Erase Codes
is
not an available menu option, consult the manufacturer’s service
manual for the correct “clear code” method.
NOTE
: The
Erase Codes
function clears DTCs from the selected
ECU or provides instructions for how to manually clear the codes
from the ECU.
Before performing this procedure, make sure the vehicle’s ignition
key is in the On (Run) position with the engine off.
To Erase DTCs, please follow the steps below:
1.
With the
Function Menu
screen displayed (Figure 5.22), select
Erase Codes
. The scan tool displays an instruction message.
2.
Follow the instructions on the screen until the procedure is
completed.
3.
When finished, press any key to exit.
4.
Use the
Read Codes
function again to check if DTCs have been
erased successfully. If any codes remain, it indicates that the
vehicle needs maintenance. Please repeat the
Erase Codes
steps
after repairing the vehicle.
Fault Codes
P0046
Battery voltage high
Status-60(No additional fault
symptom available for this DTC).
P0098
Intake air temperature sensor 2
Circuit high input
Save