STEP-V
Carefully hammer dowels in to LEFT and RIGHT END
FRAMES. Use the sanding bl ock between the hammer and
dowels to prevent marring of the wood. BACK can be
pushed slightly forward for better clearance when swinging
hammer.
*NOTE: 1” DOWEL USED FOR PLUGGING END FRAMES.
STEP-VI
Carefully drive the brass pins into the LEFT and
RIGHT END FRAMES. Once flush with the wood, use
the 1” plugs to cover the brass pins. Again, use the
sanding block between the hammer and the wood to
prevent any marring of the wood.
*NOTE: DO NOT FORCE THE DOWELS. ANY EXCESS
CAN EASILY BE SANDED AWAY.
2
STEP-VII
Secure screws into pre-drilled holes of the SEAT and
the BACK as shown in assembly pictures, insert
screws through BACK ST RETCHER and into the
BACK with a proper hand held screwdriver.
*NOTE : ½” DOWEL USED FOR COVERING SCREW
HOLE IN BACK STRETCHER.
STEP-VIII
Carefully hammer the plugs into the BACK
STRETCHER to cover the screw holes. Again, if the
plugs are not com pletely flush, just sand away the
excess with the sanding block provided.
IF YOU HAVE ANY QUESTION REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*
KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200
Gateway Court, Manassas, Virginia 20109
Phone: 703-361-7000, Fax: 703-361-7001
