18
DEVICE ALIGNMENT
When tying two or more devices to the IGLA ALARM,
the alignment should be conducted in the PIN-code
change mode by entering the valid PIN- code once
again. If the gray wire is used for alignment of the
devices, all the devices added sooner will be untied.
Alignment with the AUTOSTART-module
1. Connect both of the devices according to the wiring
diagrams described in their manuals (do not connect
the red and the gray wires of the AUTOSTART).
2. Turn on the ignition.
3. Transfer the IGLA ALARM system to the PIN-code
change mode by one of the next ways:
• Connect the red and the gray wires of the IGLA
ALARM to a «plus»-wire in the car;
• In the case the device has already been set up,
enter the valid PIN-code
1
once again when the
accelerator is fully pressed
2
.
If the current PIN-code involves slight push of the
accelerator, enter the PIN-code once again and
after that press the accelerator to the floor.
4. Twist the red and the gray wires of the Autostart
module together and connect it to a «plus»-wire
in the car.
5. The systems will proceed to the alignment mode.
The fact of successful alignment will be confirmed
1 The initial PIN-code adjustment algorithm is described on page
number 27.
2 A different operative organ is used in some of the cars instead of the
accelerator (see the official website https://service.author-alarm.com/).
!
!
