23
3. Twist the red and the gray wires of the
CONTOUR-module together and connect them to a
«plus»-wire in the car (the hood lock should open,
close and open again within 5 seconds).
4. Turn off the ignition and disconnect the red and
the gray wires from the «plus»-wire for restarting
of the device.
5. Connect the red wires of the devices to the «plus»-wire
again (do not connect the gray wire anymore).
Alignment with the KORD-module
1. Connect both of the devices according to the wiring
diagrams described in their manuals (do not connect
the red and the gray wires of the KORD-module).
2. Transfer the IGLA ALARM system to the PIN-code
change mode by one of the next ways:
• Connect the red and the gray wires of the IGLA
ALARM to a «plus»-wire in the car;
• In the case the device has already been set up,
enter the valid PIN-code
1
once again when the
accelerator is fully pressed
2
.
When tying two or more devices to the IGLA ALARM,
the alignment should be conducted in the PIN-code
change mode by entering the valid PIN- code once
again. If the gray wire is used for alignment of the
devices, all the devices added sooner will be untied.
1 The initial PIN-code adjustment algorithm is described on page
number 27.
2 A different operative organ is used in some of the cars instead of the
accelerator (see the official website https://service.author-alarm.com/).
!
