37
The key fobs with no buttons may be added to the
device with the radio module version 7.2 or above
(see the information on the label on the box).
1. Retrieve the power supply elements out of all the
key fobs (including the key fobs previously added
to the system) and turn off the Bluetooth on all the
smartphones.
2. Erase all the buttons previously recorded in the
memory of the system (see «key fobs deleting»
paragraph) and turn off the ignition.
3. Enter the key fobs adding mode as shown in the
respective passage on page 34.
4. Close the pins on the key fob
print manually (using a piece
of electrical wire or a piece of
some other material that can
conduct electric current) as
shown in the picture on the
right and insert the power
supplying element. The diode
will fl ash once in a second.
5. Break the contacts. The fact of successful connection
will be confi rmed by the red diode light.
Adding of the second key fob is possible right after
the fi rst one without leaving the «key fob adding»
mode. The second key fob may be paired later
as well by repeating all the procedure from the
beginning (in this case the key fobs deleting is not
required).
6. Turn off the ignition.
!
!
