SETTING OF WIRELESS PUSH BUTTON
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24 25
1.Motor Terminal
2. DC24V
3. GND
4. UPS +
5. UPS -
6. E-Lock -
7. E-Lock +
8. Function select Signal terminal
9. DC13V +
10. GND
11. Photocell
12. DC13V +
13. GND
14. Inside Sensor
15. DC13V +
16. GND
17. Outside Sensor
18. DC13V +
19. GND
20. Pet signal terminal
21. DC13V+
22. GND
23. Function Select DIP Switch
24. Open Speed Adjustment Knob
25. Opening Time Adjustment Knob
TERMINAL INTRODUCTION
Add:
Press the learning button for few seconds till the indicator turns blue, then
press any button of the remote, learning is done after indicator flashes 3
times.
Delete:
Press learning button for few seconds till the indicator turns blue, after the
indicator flashes 3 times, all remote learning is deleted.
Please verify carefully the DIP switching selection is same as during
learning process.
POWER CUT MEMORY FUNCTION
All settings will be saved when the power goes off
.
Door will be closed slowly, if it is
open. Once the power is on, the Multi-Controller resumes normal working (the
working mode is same selection before power off).
22
21
