Tighten the screw
Move the door leaf
to reduce
resistance. The
controller should be
smoothly working.
Two wireless push buttons are supplied with Prime Lock, one for each side of the door.
i.
Measure 3 feet (1m) up from the floor and mark on the door frame, inside and out.
Ensure the frames are clean, dry and free of dust, grease etc.
ii.
Peel the double-sided tape on the back of the push button.
iii. Attach the push button onto the frame to cover the marks made in step (i).
Affix the wireless
push button.
Mount it on to the
desired position.
Power on, to test
the system
Cover the
controller after all
the test is done.
STEP 4: CONTROLLER INSTALLATION METHOD 2
Attention: This is to ensure that door can be fully
opened. This would take off the right end cap of track,
make door leaf and the rack to be flat.
Place controller on
top of door frame
when door is fully
closed. Position it
from center of the
whole door at 1.6in
/ 40 mm right. Mark
the ends by pencil.
Adjust the
controller position
within the
markings, leaving
0.9in / 25 mm
distance between
controller and door
leaf.
14
13