EXP-52
3
6. OPTIONAL ACCESSORY OPERATION
Simultaneously pressing both the ON/OFF and AUX buttons will allow
third channel operation. A negative pulse begins and will continue until
buttons are released. It is not recommended to press the buttons
longer than 3 seconds.
7. SECOND CAR OPERATION
Refer to SECTION “(K)” of this operation manual. Arming and disarming
will be determined by how the transmitters have been programmed for
multiple vehicle operation.
8. CHANGING THE REMOTE TRANSMITTER BATTERY
The EXP-52 remote transmitter uses one (1) 12 volt miniature battery,
#EL12, #VR22, or Radio Shack #23-144. It will provide approximately
one year of operation before replacement is necessary.
To replace the battery, carefully remove
the case screw located at the end of the
remote where the key ring attaches to the
case. Use a small blade Phillips
screwdriver. Before removing the battery
note the direction of its terminals. Install
the new battery exactly the same, using
caution so as not to bend, or otherwise
damage the battery contacts. Replace the
case cover and carefully tighten the screw.
Do not over-tighten the screw!
Test the
transmitter to insure it arms and disarms
the alarm.
+
-
