Auto Page RF-302, Operation Instructions Manual

RF-302

2

 
3.  PANIC FUNCTION 

 
The RF-302 remote control may be used as a remote panic switch to 
trigger the siren in cases of emergency.  To activate the PANIC 
FUNCTION press and hold the ON/OFF button on the remote transmitter 
for a minimum of 3 seconds.  The siren will sound.  To stop the PANIC 
FUNCTION press the ON/OFF button on the transmitter. 
 

4.  THE PRE-WARNING SENSOR CIRCUIT

 (If installed) 

 
The RF-302 offers an option to pre-warn possible violators with siren 
chirps before triggering the alarm. The alarm will trigger with the third 
violation within 15 seconds.  Purchase of an optional sensor will be 
required. 
 
To delete the pre-warning sensor, press the button again within 5 
seconds after arming.  The siren will confirm deletion with a low chirp. 
 

NOTE

:  Deleted sensor(s) will return to normal operation upon 

disarming the RF-302.  Sensor(s) deletion procedure must be followed 
each time the RF-302 is armed.  This operation deletes only the pre-
warning sensor of the alarm.   
 

5.  CHANGING THE REMOTE TRANSMITTER BATTERY 

 
The RF-302 remote transmitter uses one (1) 12 volt miniature battery, 
#EL12, #VR22, or Radio Shack #23-144.  It will provide approximately 
one year of operation before replacement is necessary.