Installation Guide
P. 15
3
BLACK /
GREEN
(–)
AUX 2 output
500 mA programmable negative output.
4
BLACK/
BROWN
(–)
Priority door
output only
Gives a negative pulse on the second press of the
button.
5
YELLOW
(–)
Parking
Light output
500 mA negative Parking Light output
Note: Ensure that the voltage does not vary when the dimmer control
switch is turned up or down. If this is the case, you have selected the
wrong wire.
WARNING! There is also a positive Parking Light output. Only one of
these two outputs needs to be connected.
Auxiliary
Relay
Fifth
Relay
Output
Remote car starters of this series are
equipped with an on-board high-
current programmable 5
th
relay that
can be used to power a second
ignition, accessory or crank wire. The
unit uses 3 sets of pins; each set
corresponds to a specific function of
the output. In order to activate one of
the three possible functions, you must
place the jumper (supplied) on one of
the three sets of pins and connect the
14 AWG wire to the second
IGN. / ACC. /
CRANK
wire of the vehicle.
Caution!
Only one set of pins can be used at one time. Using more than one jumper may result in serious
damage to the vehicle.
The relay output rating on this unit is 25A at most. Defective OEM solenoid switches can
sometimes draw up to 50 or 60a, causing the 30A fuse to blow. Always verify your circuit with an
appropriate measuring device.
Manual
or
Automatic
Transmission
This module may be installed on vehicles with manual or automatic transmissions. It is originally
configured for manual transmissions. If the vehicle you are working on is automatic, it is mandatory
to make a few quick and easy modifications before the unit is connected. In the event that the