P. 22
Installation Guide
3)
Release the brake pedal.
4)
To change the timing:
a)
To increase the pulse by 3 ms, press the
button.
b)
To decrease the pulse by 3 ms, press the
button.
c)
To increase the pulse by 10 ms, press the button.
d)
To decrease the pulse by 10 ms, press the
button.
5)
To save the new settings: press
and
. The siren/horn will chirp 3 times to
indicate that the settings have been successfully saved.
Setting
the
unit
into
Ready
Mode
If the vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected. Therefore, you must follow the appropriate procedure between the two
described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by handbrake
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector
is in the neutral position.
2.
With the engine already running, apply
the parking brake once and release
the brake pedal.
2.
With the engine already running, apply
the parking brake twice within 10sec.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3.
Within 20 sec. of engaging the parking
brake, press and hold
,
or
on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4.
Remove the key: the engine will continue running.
5.
Exit the vehicle and close all doors, hood and trunk.
6.
Press for approx. 1 second either:
•
to lock the doors and shut down the engine;
•
to unlock the doors and shut down the engine;
•
to shut down the engine without affecting the doors.
7.
The icon will appear on your screen.