P. 24
Installation Guide
Secure
Lock
This feature allows the module to control certain OEM factory alarm systems without requiring the
use of other wires for disarming the OEM alarm. (Namely, this feature is designed for OEM
systems that use the factory lock wire to arm the alarm and the unlock wire to disarm it.)
1)
Standard Secure Lock disabled: By default, the unit will send a disarm pulse before IGN,
an arm pulse once the car is remote started and an arm pulse 4 sec after the engine shuts
down.
Note:
No lock pulse or unlock pulse is sent at any moment of the remote start sequence.
2)
Standard Secure Lock: If this Option is selected,
at remote start, the module will send an
unlock/disarm pulse (disarming the factory Alarm)
before start-up, lock pulse when the
engine is running, and lock/arm pulse 4 seconds after it shuts down the engine.
Note:
The unit DOES NOT send an arm pulse while the engine is under remote start.
3)
Smart Secure Lock:If the vehicle was previously locked with the remote starter transmitter,
at remote start the module will send an unlock/disarm pulse before start-up, lock pulse when
the engine is running, and lock/arm pulse 4 seconds after it shuts down the engine.
If the vehicle is initially unlocked, the unit will not send a lock pulse, arm pulse, unlock
pulse or a disarm pulse at any moment of the remote start sequence.
Note:
The unit DOES NOT send an arm pulse while the engine is under remote start.
AUX
3
output
This 500 mA negative AUX 3 output (trunk output) can be used for many different applications. The
output can be programmed to give a 1-sec. or to give a continuous output as long as the
button
is held down.
OPTION 1
Constant output: Pressing and holding the
button for more than 5 seconds
will send a disarm pulse and a negative pulse to the trunk wire as long as the
button is held down (maximum of 15 sec.). A rearm pulse is sent after 30sec.
(passive mode).
OPTION 2
1-sec. trunk pulse: Pressing the
button for 5sec will send a disarm pulse, a
1sec negative trunk pulse and a rearm pulse after 30 sec. (passive arm).
AUX
2
Note: This 500 mA negative Aux 2 output can be used for many different applications
OPTION 1
Car Finder. The siren will sound once each time the
and
are press
simultaneously
.
OPTION 2
Toggle ON/OFF for a maximum of 30sec. Press and release
to select
L-01 and then press the
button to activate AUX-2.
OPTION 3
AUX-2 constant output (15sec). Press and release
to select L-01 and
then press and hold the
button to activate AUX-2.
“Home
Valet
TM
”
Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote, but the
alarm functions will remain active.
