Version 07/2019
User Manual
This user manual explains how to set up the autoaid Connected
Car System. Please read these instructions carefully prior to
plugging the dongle device into a vehicle.
STEP 1
Make sure that the ignition of the car is turned off and open the
OBDII port compartment located under the dashboard.
STEP 2
Plug the device into the OBDII port so that it firmly holds in place.
Do not apply excessive force when plugging in.
STEP 3
Turn on the ignition and drive the car for at least 5 minutes. The
inital dongle set-up will be completed automatically without any
further input necessary from the user.
Access the connected car data by using the online log-in
credentials that have been provided to you separately. If you have
any problems loggin-in, please contact the autoaid support team.
DO NOT disassemble the device. Opening the device
can result in damage to the hardware. If the device is
damaged, please contact autoaid for further instructions.
DO NOT remove the SIM card from inside the dongle
without contacting autoaid first. DO NOT insert any other
SIM card than the one provided to you by autoaid.
In case that any problems occur, please stop the car,
turn off the engine, disconnect the dongle device
and contact the autoaid support team for further
instructions.
