7
On the Small Office Building Door Styles palette, click Tutorial-Double Door, and add a door to the conference
room to the right of the bathrooms:
■
On the Properties palette, enter
3'
for Automatic offset.
■
Click in the drawing area.
■
Select the top face of the wall at location 3.
■
Drag the cursor along the wall, and click to place the door 3' from the wall at the left.
■
Press ENTER.
Adjust the location of the door
8
Select the double door you placed at location 3.
9
Click the Location grip, and press ENTER to move the door along the wall.
10
Move the cursor to the right, enter
24
, and press ENTER.
11
Right-click, and click Deselect All to turn off the door grips.
The doors to the bathrooms should open inward. It is preferred that the door swing angle should be displayed at
45 degrees.
Change door swings
12
Select the door at location 1.
NOTE:
Depending on your cursor position when you placed the doors at locations 1 and 2, you may not need to flip
the door swings. Use the grips as necessary to complete these steps to match the doors as illustrated in step 16.
13
To change the door swing, click the Flip grip on the edge of the door.
108 | Chapter 3 Developing Your Building Model Design
