Location grip selected on MvPart
New location specified
Resulting layout
Routing Preferences
You use routing preferences to draw accurate pipe systems in
on page 252. Pipe routing preferences
specify which pipe part to insert as you lay out the pipe run. Couplings are inserted at the proper pipe length
and at
on page 297 in the pipe run. Routing preferences meet design standards and specifications
and contain the pipe parts (pipes and fittings) used to lay out your pipe run.
A pipe part routing preference includes one or more
on page 280 for pipe parts and fittings, such
as elbows, tees, laterals, and transitions. The software organizes the size ranges based on nominal pipe
diameters. You can use pipe parts and fittings in a specified size range as you lay out the pipe run. The
following example shows the routing preferences for Glued. Notice that the Pipe drop-down list organizes
the available parts based on material type (US Imperial and US Metric profiles).
250 | Chapter 7 Drawing Piping Systems
Summary of Contents for 235B1-05A761-1301 - AutoCAD MEP 2010
