3
Move the cursor over the MvPart connection to display the pipe end connector.
4
Click the pipe end connector to connect the pipe run to the MvPart.
TIP
You might be prompted to accept or undo the connection.
If the pipe segment centerline is not aligned with the MvPart connector centerline, the software
automatically presents
5
If the size or connection type of the pipe segment does not match the size or connection type
of the MvPart, specify the fittings to use to make the connection:
then…
If…
a transition fitting is automatically inserted. Accept the connection.
If a transition is not specified in the routing preference, the
prompts you to specify the transition.
the pipe size differs from the MvPart
connection size
the
prompts you to specify the fittings for this
connection.
the pipe connection type differs from
the MvPart connection type
specify the fitting on the
on page 286, and insert
it at the end of the pipe run. For more information, see
you want to use a fitting in the part
catalog that is not configured in the
routing preference
on page 305. Once the fitting is inserted, you might need
to move the fitting to connect the pipe run with the MvPart.
Adding a Vertical Segment to a Pipe Run
1
on page 291 and begin
2
Specify the point in the layout where you want to start the vertical segment.
The elevation at this point is the start point of the vertical segment. You can specify start and
end elevation values later when you
on page 325.
3
on page 286, under Placement, specify the elevation of the endpoint
of the vertical segment.
Adding Pipe | 301
Summary of Contents for 235B1-05A761-1301 - AutoCAD MEP 2010
