In this example, the Select Connected Branches command is used to select a plumbing run.
2
Click
(Quick Select) at the upper-right corner of the Properties palette.
3
On the Quick Select dialog, specify the filter properties:
■
For Object type, select Plumbing Fitting.
■
For Properties, select System.
■
For Operator, select =Equals.
■
For Value, enter ByLayer.
4
In this example, the selection set was filtered by part type. Now, only the elbows in the run are
selected.
5
In the How to apply section, select Include in new selection set.
6
If you want to append the results of the Quick Select to the current selection set, select Append
to current selection set and click OK.
Filtering Selections by Part Type
1
Select multiple objects in your drawing.
Component Selection | 493
Summary of Contents for 235B1-05A761-1301 - AutoCAD MEP 2010
