Modifying the Style of a Plumbing Line or Fitting
1
on page 492 the plumbing line or plumbing fitting in your drawing.
2
Click Home tab
➤
Build panel
➤
Tools drop-down
➤
Properties
.
3
On the Design tab of the Properties palette, under Style, specify a different style.
NOTE
Alternatively, you can select a plumbing line and click Plumbing Line tab
➤
Modify
panel
➤
Modify Plumbing Line
, to change the setting for Style.
Plumbing line styles are based on information such as the size, type, and gauge of the material (i.e., Schedule
40 Carbon Steel or Copper Tube). Plumbing fitting styles are based on information such as type (i.e., tee,
cross, trap, or check valve) and subtype (i.e., 45-degree mitered, 90 degree long-radiused, or 3-way). The style
determines the appearance and function of the plumbing fitting. For more information on styles, see
Configuring Styles for Plumbing Lines and Fittings
on page 481.
Calculating the Sizes of Supply Plumbing Lines
Before you size a supply plumbing system, you should:
■
Complete a draft of the system.
■
Verify the accuracy of the fixture unit table you are using. For more information, see
on page 479.
■
Create a sizing table for supply plumbing lines based on applicable codes, such as the Uniform Plumbing
Code, or verify the accuracy of the table you are using. For more information, see
on page 480.
NOTE
You can only size supply plumbing systems whose system type is Hot Water or Cold Water.
Sizing Supply Plumbing Lines
WARNING
If you make any modifications to the supply system, you need to resize the plumbing lines.
1
Complete a draft of the supply system.
2
Select a run whose system type is Hot Water or Cold Water. When you select the run, specify
the point on the run at which to find the flow rate, velocity, and plumbing line diameter.
3
Click Plumbing Line tab
➤
Calculation panel
➤
Size Plumbing Line
.
NOTE
To calculate sizing values without resizing the run, access the sizing calculator by clicking
Analyze tab
➤
Plumbing panel
➤
Size Plumbing
, and then press ENTER at the command prompt.
Calculating the Sizes of Supply Plumbing Lines | 501
Summary of Contents for 235B1-05A761-1301 - AutoCAD MEP 2010
