13
Specify what constructs to use in the view. The constructs you select are attached as reference
drawings to the view drawing. If a drawing is referenced as an overlay in a view drawing, it will
not be included when you add the view drawing to a sheet.
NOTE
If the construct drawing you want to use includes an overlay reference drawing, such as a
building floor plan, you must select the reference drawing in addition to the construct drawing in
order for it to display on the view drawing.
14
Click OK.
15
In the drawing, specify corners of the elevation region. The parts of the drawing in the elevation
region will be included in the new drawing.
16
In the general view drawing, specify the insertion point for the new elevation view.
The new view will not be inserted in the general view drawing; you are specifying its location
in the new drawing. It is recommended that you specify a point away from the drawing geometry.
You can use the zoom and pan commands to move to an open area in the drawing without
closing the generate elevation view command.
574 | Chapter 12 Creating Construction Documents
Summary of Contents for 235B1-05A761-1301 - AutoCAD MEP 2010
