Adding Keyframes
21
To copy a grade to the current shot from another shot in the Storyboard:
1.
Scroll to the shot you would like to copy grades to by performing one of the following two
actions:
•
Hold down the ALT button on the Navigation panel and then press the Frame Forward or
Frame Back button to temporarily apply the grade from the previous or next shot to the
current shot.
N
OTE
:
Each time you press ALT and Frame Forward or Frame Back, you move one shot at a
time through possible sources to copy back to the current Storyboard position. For example,
if you hold down ALT and press Frame Forward three times, you see a preview of the current
Storyboard position with the grade from three shots ahead applied.
•
Press Offset on the Navigation panel and then scroll through the shots by pressing the
Scroll button and using the ring portion of the trackball.
2.
Press Do to permanently copy the grade from the shot outlined in blue to the current shot.
3.
Press the ALT button to cancel the operation.
Adding Keyframes
When you animate parameters, you can set keyframes using the Mark button.
To add keyframes:
1.
Go to the frame where you want to add the keyframe.
2.
Press Mark.
3.
Modify the parameters.
4.
Repeat the above steps as required.
.
1
-
4
7
5
6
9
8
2
0
+/-
RECALL GRADE
3
ALT
ENTER
CURSOR
REVERT COMP
UNDO
REDO
DO
RESET OFFSET
SCROLL
CLIP
A/B
MARK
ALT
Frame Forward
Frame Back
Offset
Summary of Contents for CP100
Page 1: ......
Page 4: ......
Page 76: ...The Tangent CP100 Control Surface 2 70 ...
Page 80: ...74 Index ...
