15
Turn on
DIP
3 switch to
OFF
, without auto close function.
Turn on
DIP 3
switch to
ON
with auto close function.
Auto close time setting: Turn on DIP3 switch and DIP6 switch to ON,
Each press of F key the auto close time delay one second, when reach the demand time,
return DIP6 back to OFF. Auto time setting is completely. When setting auto close
function, the door open to the limit, and perform auto close delay, at the same time function
light flash in 1HZ.
When reach the setting time, the door will auto close.
DIP 4 switch: Soft start and stop function
Turn on DIP 4 to OFF, without soft star and stop function.
Turn on DIP 4 to on, with soft star and stop function.
DIP 5 switch : Maximum starting torque function
Turn on DIP 5 to OFF, the motor starting by MT force
Turn on DIP 5 to ON, the motor starting by full output torque
DIP 6 switch : Set
Turn on DIP6 switch to ON to set the function of circuit board, and return it back to OFF
when the setting is completely.
Auto close function setting:
Users can set the auto close function as their need: stir
DIP
［
3
］
to
ON
, auto close function
Working, shut down when connect to
OFF
. When the auto close function working, the
door travel to limit and execute auto close timing with indicator light flash at 1 Hz. When
reach the Setting time, the controller execute auto close operation.
Soft start and soft stop function setting:
Noted that the soft start and soft stop function can only be set after installation of open and
close limits→power off→ Turn on
DIP 4
switch and DIP 6 switch to
ON
→ power on→
press
F
key two seconds→ motor start and the door open completely→auto close→ close
completely→
Return
DIP 6
switch back to
OFF
→setting completely.
Note: DIP 6 switch must be return back to OFF after setting.
Otherwise F key as single open function will be invalid.
Function adjustments: increase by clockwise, decrease by anticlockwise
