INSTRUCTIONS VELOSE-80A
Page 11
SLIDING GATE OPENER
*Instructions for photocell:
During closing, if active the signal of photocell, the PCB will activate opening operation
when photocell sensed the obstacle, the door will be stopped then opened immediately
after remove the obstacles, the door will operate according to the new command
7. Remote Control Setting
7.1
Activating the Remote Control
Press and hold down the “F” button for approximately one second until FF appears
blinking on LED then release button: Pointing the remote at the PC board press any
button on the remote, Remote should now be activated.
* 50 remote controls can be set at most
*Verify the remote control is activated by pressing the remote control button. The LED will
be on/of
7.2 Erasing the code
Press and hold down the “F” button for approximately 1 second Until
“FF” is blinking on LED, release the button then press down the “Enter” button on the PC
board.
8. Total Timer Adjustment for Opening & Closing Gate(Motor Setting)
Gate must be in the closed position before starting the total time for opening gate.
On the PC board hold down the “+” button until “AA” appears on the LED.
Holding down the “P” button & “open” button together on the remote until the indicator on
the PC board is blinking, Release both buttons. The motor will start moving at low sped
then stop once the OPEN magnet reaches the motor sensor.
